Grayguy

Ok, I have been searching multiple forums for about an hour now and can't find what I need.

Somewhere out there is a picture of the mounting holes size/location needed for making your own bumper brackets. I know it exists because I saved it at one point, but my old PC crashed and I lost all of that. So can anyone point me in the right direction or post it up?

DualPurposeXJ

front or rear bumper?

Gatchmo5710

If you go out to your jeep u can just measure away. Put a piece of card board and mark the holes.

Grayguy

Front bumper. I'm well aware I could figure it out on my own, if I wanted to do that why would I be asking? I want to make the brackets up before hand so I have them done when i pull my steering box off this weekend, and I don't want to spend the time this weekend on making the templates then brackets before I can reassemble.

Gatchmo5710

so you want us to waste our time searching for you? when you wont 1:search yourself or 2: make your own.

Grayguy

Just searched for over an hour for it. Pretty sure it was on Pirate somewhere but I couldn't find it again. And no, I don't want you to search for me, I assumed I wasn't the only one of the 1000's of XJ owners who may have saved it when they came across it.

Dan91

http://www.twisted-halo.com/digicam/...er%20mount.pdf
There ya go

Grayguy

Thank you very much for posting that, really helps a lot.

_hemler_

I found that only a few of the holes actually line up and you'll have to drill new holes in the frame or different ones in the bracket other then that they worked great

_hemler_

Does anyone have a pdf on beefier rear bumper brackets?? If so that would be a great help thanks guys