a_shirey

And do you realize how built his XJ is?

That thing is made for 37s.

Acerwin

I meant to say jeep not looks

Acerwin

I guess I'm just going to stick with my 35's then and just upgrade my d30/35 axles or should I if I can get them go ahead and at least put a ford 8.8 in the rear?

harlow388

I new to this. I'm a mom with a kid just about to go off to college and I need help!! Can anyone tell me who to talk to about a "no spark" problem I'm having on a 98 jeep grand cherokee laredo V6 Automatic. It just took a poop the other day and I can't figure it out for myself???? Please? I'm very desperate! thanks!

mr white

Get at least an 8.25 29spl in the rear and gear it before you put 35s on. Takes a lot of work to run 35s reliably.

mr white

You have any check engine lights? Also might post a new thread, you'll get more responses...

surfandfish1120

Hey Ill be getting a rough country 4.5 inch lift and my buddy has 33 inch nito desert tires, would this fit ok or would I need to do some trimming? Anything extra I would need other than the lift and tires?

muskrat

Post in grand cherokee
Some one can help you there.
Good luck!

Parsnip

Agreed, I currently have an 8.8 in the rear, its not geared properly yet but I will say the 3.73, factory posi and 31 splines are working perfectly, an also since I swapped in an ax15 I can pull 4.10 r&p out of a sport edition (or whatever had them) and be a little bit over geared for about 150$ in gears + master kit. But even as it stands, I can burn 35s and have no axle wrap (thank your ruff stuff 7" leaf perches) and no concerns about strength its not really even that hard of a swap

BrewinXJ

I am going to start my 3" lift this weekend but not sure if I have all the tools I may need.

I have already used the search engine with no luck.

Can someone provide a detailed list of what tools I will need. I know I can go out and do dry run but I am trying to avoid that route.

Thanks in advance

mr white

Metric sockets. Pb blast. Hammer. Pry bar. Breaker bar. Open end wrenches. 18mm. Pickle fork. Thread lock.

NewKindOfClown

21mm for leaf spring and control arm bolts.

muskrat

I also needed torch, angle grinder,extra PB,wood blocks
Anti seize for re install.
Start PB twice a day now.

Acerwin

So the Chrysler 8.25 should pull 35's with no problem? And should I go ahead and upgrade my d30 to a high pinion d30?

Acerwin

Ok I'm going to get a 8.8 from an explorer so what all needs to be done to swap that into my jeep? Really need help on this never have did something like this before so any comments or concerns would be great.