I hate that she won't let me just drive her and always needs to have a problem. She's such an attention hog.

 

Three trips to the dealer. a re flash was supposed to take care of it. Transmission " thumps at low speed when more throttle is applied. dealer service says this is normal. I say BS, I read in an Edmunds review that others have experienced it. Chrysler needs to come up with a fix or I am filing under my States Lemon Law.

 

Trying to stop fast... Rear disc brake conversion coming soon.

 

On an old XJ? Good luck with that.

 

You must be on the ap.

jeep won't admit to the transmission "thump" in 2013 Gr Cherokees with quadra trac
Three trips to the dealer. a re flash was supposed to take care of it. Transmission " thumps at low speed when more throttle is applied. dealer service says this is normal. I say BS, I read in an Edmunds review that others have experienced it. Chrysler needs to come up with a fix or I am filing under my States Lemon Law.

 

My XJ makes all kinds of noises.

 

2013 Grand Cherokee.

 

Yep, on the ap...and the toilet. How did I ever crap before the smartphone?

 

Didn't take near as long, that's for sure. Saves a lot of room in the bathroom as well, reading material is no longer a requirement.

 

Well worth it.

The #1 thing I hate about my XJ? Rust. Nothing else, that's it!

 

The fact that I didn't have a helper today so I couldn't get my axle seals installed. Oh yeah, also that I ripped the rear shoes off today and the wheel cylinders are leaking too. I'm not looking forward to trying to get those rusty things off...

 

I've been saying this a lot lately...ditch the drums and do a rear disc conversion. It's well worth the time and effort. Why do you need a helper to install axle seals? I was fine on my own..

 

I'd love to do the disc conversion, just tight on cash. I couldn't get the new seals pounded in and I needed someone to either operate the hammer through the axle hole or hold the big socket on the new seal.

 

I hate this stupid exhaust leak I have and a whiny bearing somewhere after I replaced all wheel bearings & u joints

 

Ohhh, the INNER seals. Haven't done those yet