Bought and installed a TB Spacer... Not bad for 40 bucks..

Also bought a nice sound system for a great deal!

 

messed with my bumper, added JCR prerunner hoops, getting d rings soon, and installed IPF h4's with hella xenon bulbs, WOW!!!!

 

actually yeasterday and last night i put on my shiny new sway bar discos, and adjustable trac bar all from rustys...now i just need to put my t-case drop in and the rear shocks (shocker) in then the lift is complete and pic time

 

Take it off and get your money back. TBI spacers are completely useless on a MPI motor. All is going to do is whistle and howl. Seriously, not worth $.02 much less $40.

 

me and a buddy went to the local pick and pull... got myself some coil springs from a bronco (hope they fit) and also a pair of dakota 4x4 leaf packs for my bastard pack.
now i just gotta find a good write up on how to do the bastard pack and get to work on it!
im guessing ill get a little over 3" lift maybe even 4" dunno if it'll need a t case drop or sye yet

 

Wheeled her a bit stopped fished with the boy then came home and ate fish. Good day in my book.

 

replaced gauge cluster to get speedometer to work and it didnt also put new seat covers in and tomorrow im going to find new front suspension kit and motor mounts to try and get this death wobble to stop at 60 miles an hour +

 

topped tranny fluid spent most of the day rebuilding the crappy chinese four wheeler but its running so the day was not wasted

 

Found some mud trails and rode around our flooded streets

 

I killed my alternator in a mud hole today.

 

New valve cover gasket, oil change, and welded my exhaust back on after ripping it off last week....oh, and had a friend wipe the mud out of the inside of it and vacuum the carpet.

 

Smoked the rear pinion bearings in my 60 to the point smoke actually came out by the yoke.

 

that sucks ***. like, how does one even do that to a Dana60?

 

Too steep of a pinion angle so my oil slinger didn't sling oil. I'm going to drop the angle about 2 degrees and move the fill plug up about 2 inches, swap the bearings and I should be golden. It's a junkyard axle and I didn't check the pinion bearing since the carrier bearings and wheel bearings were good. With my luck should have known.

 

bought a 92 cherokee today... time to play...just gotta learn how this **** works now.. my cfirst project was a 97 eagle talon... gotta go from the lowering idea to lifting!! haha