Originally Posted by 92sw

You have a better pic of.the boxs

Originally Posted by NewKindOfClown

(Copied from my build thread) Started by tightening up the last two bumper bolts which we couldn't get to last night, and then I took on the task of trimming down the tire stops. This took a lot of effort with my Buck knife, and it turned out to be a waste. I needed to use the lower part of the block so the bolt head would have something to catch. This lead to the smartest decision I made all day: 15 seconds in the microwave let me cut through the rubber like butter, and it had the added benefit of filling my apartment with the soothing aroma of burnt rubber. With the stop trimmed down properly this time, I installed and duplicated. The license plate clearly couldn't stay there, but I couldn't come up with a place to attach it. Advance Auto didn't have a receiver mount or a tire carrier mount for the plate, and all the other local stores are closed on Sundays. I'll have to order something. In the meantime, I slid it between the bench and the sub box. It held in place during the test drive. Now I still need a license plate mount and a cap for the 1.75" square opening on top. I also need a wheel for my spare tire, which I was sure I had until I opened up my storage unit. All in all, it was a good day.

Originally Posted by Tyback

Nice but I think this would be better suited in a YJ thread. Good job.

Originally Posted by cruiser54

He has both. And we're always interested in what Clown is doing. Perhaps you should sit back and watch instead of slinging ******* comments out.

Originally Posted by NewKindOfClown

Thanks, cruiser. I'm biting my tongue to avoid another derailment in this thread.

For the record, this was What Did You Do To Your Jeep Today?. When it was merged with a similar thread, this title was kept.

Originally Posted by 94chopedandlocked

Needs cleaned and painted. Just plated bottom of old pocket and welded it to plated frame and bumper brackets. Shouldn't go any where. And the actual mount is just 2 pieces if angle cut and drilled

Originally Posted by 92sw

Nice how do they perform

Originally Posted by 94chopedandlocked

I wish I knew lol. Jeep has been on jack stands for a month or so getn one tons and a lot of little things. I did pick up rear of jeep with an engine hoist and the shackles move/flex alot. Factory ones barely moved back and forth and were straight up and down

Originally Posted by rmoore1031

I put my boat on the roof.