Started the day by removing the intake and exhaust so I could weld up the crack in my manifold. Got that welded and figured that now would be a super time to replace the leaking valve cover gasket. Then reinstalled the repaired exhaust and the intake with a new gasket.

 

Sat down with an assortment of drill bits, a center punch, a power drill, a 17mm socket/ratchet, a hammer and a can of Sprite. I didn't get up until the other side of holes were done for my RC crossmember. My leg fell asleep and I bent the 25/32" drill bit on the last hole because it caught the last little bit of metal. It's done though.

 

Ran blocker for a disabled vehicle

 

Dam thats a big hole.

 

Tried to install the last of my LEDs but the very last one was broken. So I had to get em to ship me more. Yay another week with the dash tore to hell. :l

 

Where did you buy your leds from?

 

I got the bulb numbers then ordered em off ebay. Made sure to get an American shipper so I didnt have to wait 3-4weeks.

 

I went and got mine from amazon and got them in bulk for 5$ for a pack of 10 and I got them in 2 days

 

Yeah I ordered amazon when I did my truck and made sure I got an American shipper. I am prolly gunna order my reverse lights off amazon since their cheaper.

 

Went camping

 

I went to the top of the south hills above Helena, beautiful viewthe last pic is the Sleeping Giant from about 35 miles.

 

I was lazy and didn't fix my Jeep. instead I did this

 

You were bored lol. Looks fun

 

The back up that jeep looks surprisingly comfortable to camp in.

I ended up adding some brake fluid, noticed it was pretty low, plus I am leaking a little out by the driver side rear drum. I am assuming the heat is killing it but I will get that checked out next week. Also noticed I am low on coolant, so that is tomorrows task.

 

oh it was fun. can't wait to fly it again in the morning. maybe I'll try landing on the Jeep...lol. My other helicopter I could fly completely through it if it was working.