When you do the bedliner do you have to prime anything first or just tape and spray away

 

got the back pan welded in, its bed lined an sealed now, the front is a pain because the trans tunnel was rough

 

I prime for extra precautions ,,don't know that you have to or not

 

Disregard that question I was able to find it on search and found it's better to sand down the area, clean then spray. Might have to do this one weekend

 

most of the cheaper spray bedliners don't stick to primer as well as they stick to bare metal.

 

Made brackets for my Coil Pack after my head swap

 

Rear LED cargo lights.Attachment 59413

 

I like it! What lights did you use?

 

my oil pressure would read like 1 at idle and then read 13 then back down again,and thats after i changed my oil. so i went to harbor freight and bought the oil pressure tester kit and hooked it up,and found the readings were about the same,so i took it off and happened to look under the jeep and seen a small puddle of oil just below where the sensor goes. i realized i didnt hav the pressure test gauge fittings tight enough,to get an accurate reading,so i just put the sensor back on,and was thinking, i didnt hav the sensor screwed all the way in from a couple of years ago as i turned it in all the way until it was tight. put the wire back on and started it and it read 13 to 15. im wondering if thats where all my oil was going, squirting out the bottom of the sensor screw threads under pressure. ill know for sure this week while driving to work. if it isnt working better,i know ill hav to take the pan off and clean the pump and screen or put a high pressure pump in.

 

i feel your pain...i had a jeep like that once..parted it out at least your "main frame rails" are still intact mine were rusted through

 

Lol. He's not talking about rust!

 

Camped in it. Did some minor league wheeling, but I still need to trim my fenders.

 

Thx
I got them from superbrightleds.com they were cheap. and have all kinds of shapes and sizes.

 

Looks good at night, but pictures, locations, switch or limit switch and what you ordered would be great to see. I really like how it illuminates the back. Looks great!

 

Question of the day?? I had someone at work ask me if I would trade my XJ for his TJ .. I have a 01 with a 109xxx miles and a 4.5 lift and 32's .. his is stock 99 but the front bumper with 120xxx ... what do you think about that