How do i ethier reinforce steel under car or get rid of rust on bottom of drives side front seat basically every where Lol but its not bad bad Any suggestions anything could help

 

Cut it out and weld in new

 

Would that be the cheapest

 

Not necessarily but its the best option

 

if its not soft yet then clean it up and paint it

 

Ok

 

That's what I did where it wasn't rusted through. Cleaned up, hit it with red rust converter primer, then a satin black rust topcoat. Going eventually bedliner/similar the whole floor.

 

Like others have said, rust converter will help. I used a good bit of that and bedlined every inch of the underside for all the surface rust. Any hole I found got cut out. The hole was patched over with stainless sheet and riveted down. I used silicone caulk to keep moisture from between mating surfaces. There's 25,000 miles on the first patch I did...still looks good as new.

 

remember,drivers seat,rust,weak floor,accident? make sure that area is strong enuff, to not be replaced

 

yeah it would suck if something came right through and skewered you, possibly in the nuts ect. would not be a good day.

 

But anywho... i was wondering what the best DIY bedliner i could get would be?!?!? im looking at herculiner or Dupli-Color with kevlar... both sold at autozone. any thoughts?