Online store recommendation
Thread Starter
Senior Member
Joined: Jul 2012
Posts: 722
Likes: 0
Year: 1999
Model: Cherokee
Engine: 4.0L I6
I need some OEM stock engine mounts for my '99, anyone have a suggestion on where to find them online at a good price? I have brown dogs currently but the vibrations are a bit much for me with the truck being a DD.
Thanks for any suggestions.
Thanks for any suggestions.
Trending Topics
CF Veteran
Joined: Sep 2009
Posts: 6,322
Likes: 6
From: Summerville, Ga
Year: 1995
Model: Cherokee
Engine: 2.5 4 cyl.
The duralast will work fine. I recommend if you havent look already to check your tranny mount as well. If your engine mounts are wore out, your tranny mount is usually wore out as well.
Seasoned Member
Joined: Oct 2009
Posts: 407
Likes: 3
From: Murrieta, California
Year: 1991
Model: Cherokee
Engine: 4.0
^ this....major difference with all new mounts....i was chasin vibes for a while IE tcase drop rear shims new joints etc..replaced all the mounts vibes got a little better...pulled out t case drop and shims and viola no vibes...nice and SMOOTH.. New mounts are well worth the time and $$ even if you dont have vibes...just smooths everything out
then again I am old and cant stand even the slightest vibe or rattle
my two cents
Cameron
then again I am old and cant stand even the slightest vibe or rattlemy two cents
Cameron
Seasoned Member
Joined: Jun 2012
Posts: 270
Likes: 0
From: Corpus Christi, TX
Year: 2001
Model: Cherokee
Engine: 4.0
^ this....major difference with all new mounts....i was chasin vibes for a while IE tcase drop rear shims new joints etc..replaced all the mounts vibes got a little better...pulled out t case drop and shims and viola no vibes...nice and SMOOTH.. New mounts are well worth the time and $$ even if you dont have vibes...just smooths everything out
then again I am old and cant stand even the slightest vibe or rattle
my two cents
Cameron
then again I am old and cant stand even the slightest vibe or rattlemy two cents
Cameron
Seasoned Member
Joined: Oct 2009
Posts: 407
Likes: 3
From: Murrieta, California
Year: 1991
Model: Cherokee
Engine: 4.0
No pics but the best way to make sure just drop your skid plate/x member and look at your mount. You should have a good 2+ inches of rubber between the mount. Get a good pry bar up there and see if you can move the trans a lot. Anything cracked,squished,sagged or broken in half replace it. The 4.0 is a very torquey motor thus hard on all mounts. This is compounded if you are in low range a lot.
Cameron
Cameron


