My jeep rear floor by the trunk is completely gone. the rust on it was just so bad that i ended up dropping the gas tank and cutting the floor out. now i have a sheet of sheet metal to cut out and put in but would it be easier to buy the metal already bent and ready to weld?

 

Why are you bending it the rear floor is flat. It just needs to get cut to fit the wheel wells.

 

i need the metal to reach from where the rear seats bolt down all the way back. i didnt know if they made something preformed that i could just buy

 

Moved to chat.

 

yes, google!

 

Cut the floor out of another Cherokee and weld it in.

 

haha well yea but i didnt know if it would be easier to buy it premade or just fabricate it myself. that was my question

 

The floor out of another Cherokee is premade

Just depends on your level of skill, for some it would be easier to just fabricate a floor, others not so much. Decide which party you belong in and then do accordingly.

 

yea i started doing it myself and its not all that hard.