Need some ideas!
Thread Starter
Member
Joined: Dec 2013
Posts: 176
Likes: 0
From: VA, USA
Year: 2001
Model: Cherokee
Engine: 4.0 L, Inline Six
Need some ideas!
Alright yall,
My work just got a plasma table for our HVAC products. It wont do anything thicker than galvanized sheet metal. Yall have any ideas of different stuff I could make on lunch, I'm so unoriginal and already ran out of stuff to cut.
My work just got a plasma table for our HVAC products. It wont do anything thicker than galvanized sheet metal. Yall have any ideas of different stuff I could make on lunch, I'm so unoriginal and already ran out of stuff to cut.
Junior Member
Joined: Dec 2014
Posts: 89
Likes: 0
From: rockinham VT
Year: 1994
Model: Cherokee
Engine: stock I6
may be some patch panels for floor replacements. How big is the table?
Thread Starter
Member
Joined: Dec 2013
Posts: 176
Likes: 0
From: VA, USA
Year: 2001
Model: Cherokee
Engine: 4.0 L, Inline Six
It's an 8 by 10 table! have quite alot of room too work, I asked a guy the worked on it and said 22 gauge was pretty much as thick as possible to cut
Junior Member
Joined: Dec 2014
Posts: 89
Likes: 0
From: rockinham VT
Year: 1994
Model: Cherokee
Engine: stock I6
That is .030" I think. Pretty thin. I have a 110V plas and it will cut 3/4" plate and It's the size of a large toaster.
Last edited by ftwelder; Aug 31, 2015 at 06:14 PM.
Thread
Thread Starter
Forum
Replies
Last Post
erupert66
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
7
Sep 15, 2015 02:07 PM
cerami50
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
13
Sep 14, 2015 10:28 PM
SouthSeaPirate
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
0
Sep 7, 2015 11:29 PM
rdr8887
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
5
Sep 6, 2015 03:39 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
