Anyone run this?

http://froehlichsuspension.3dcartsto...e-XJ_p_12.html

There is only two pictures. I need to see more. For those who run this track bar, can u post some more pictures? Both on frame side and axle side.

And how exactly much of trimming on coil bucket is required?

 

Don't people who run wj knuckles have to relocate the track bar up? Shouldn't be the first one around

 

Kris says I don't have to, and it's in fact better than oem design, it helped with the articulation. He also said it won't interfere with anything else.

 

JKS, Rustys, FST and a few others make the for a D30

 

U mean over the axle or double shear track bars in general?

 

I am running it along with FSTs crossover steering. Its no comparison to the stock crap, drives so much better. Only problem is on my low lift (2.5") the tie rod is close to the bottom of the frame bracket, so I can't have much up travel. Its super beefy.
I had to cut the sway bar mounts off along with the stock track bar bracket. I trimmed the coil bucket until it fit, not too much.

 

U drive yours on the road too?


Can u take a closer picture of the coil bucket?

 

Its my daily driver. I actually didn't take any when I had it apart and all assembled you can't see much
here is about the best i could get in the dark but you can see the coil bucket. please excuse my gorgeous welds and rust (never got around to painting it after welding it on lol)

 

Thanks. How long did it take u to do it?

 

Six or seven hours, but I took my time and was also installing my lift that day.

 

How did u know how much to trim? Did it come with directions or a template?

 

No instructions but it was fairly self explanatory. Just basically trimmed until the bracket fit