31s on stock rim

Subscribe
Nov 12, 2015 | 09:28 PM
  #1  
I have been looking for new tires for my 96 jeep xj I have 30x9.50s on 03 jeep wrangler rims on my xj but I was wondering if a 31x10.50 would fit on the rim? I've heard you could as long as you keep the tire pressure low enough so it doesn't wear the center of the tread out. What is everyone's thoughts?
Reply 0
Nov 13, 2015 | 04:45 AM
  #2  
8" wheel for 31s
Reply 0
Nov 13, 2015 | 04:54 AM
  #3  
They will work just fine on the stock wheels. Ran them myself. Plenty of other folks have too.
Reply 0
Nov 13, 2015 | 05:06 AM
  #4  
Most tire companies have an approved rim width of 7"-9" for a 31"x10x15" tire.
Reply 0
Nov 13, 2015 | 06:26 AM
  #5  
have them (well the equivalent) on my stock 7" wheels..

like stated the 10.5 in most cases are rated for a 7-9 inch rim. so no issues there..


Name:  DSC_0137.jpg
Views: 2660
Size:  395.8 KB


Reply 0
Nov 13, 2015 | 07:11 AM
  #6  
Yep, they'll work just fine.

31s on stock rim-image-2570512884.jpg


Reply 0
Nov 13, 2015 | 10:07 AM
  #7  
Quote: 8" wheel for 31s
You don't need an 8 inch wheel until you get to 12.5 wide.
Reply 0
Nov 13, 2015 | 11:07 AM
  #8  
Quote: You don't need an 8 inch wheel until you get to 12.5 wide.
Iirc, rule of thumb is you're allowed up to a 4" wider tire than the rim.
Reply 0
Nov 13, 2015 | 11:15 AM
  #9  
Quote: Iirc, rule of thumb is you're allowed up to a 4" wider tire than the rim.
I believe your right and off-road you tend to push that to be able to air down lower.
Reply 0
Nov 13, 2015 | 11:20 AM
  #10  
Quote: I believe your right and off-road you tend to push that to be able to air down lower.

Yes very close to that and if the OP's budget doesn't allow for other than stock rims he "May Be" OK. I'm not for sure if there will be clearance problems if everything else is stock.
Reply 0
Nov 13, 2015 | 11:29 AM
  #11  
Quote: Yes very close to that and if the OP's budget doesn't allow for other than stock rims he "May Be" OK. I'm not for sure if there will be clearance problems if everything else is stock.
I forgot about the lca it will probably run there at full lock.
Reply 0
Nov 13, 2015 | 11:31 AM
  #12  
I run 31x10.5 on my stock rims and rub a little bit at full lock.
Reply 0
Nov 13, 2015 | 05:33 PM
  #13  
Quote: I run 31x10.5 on my stock rims and rub a little bit at full lock.
this

until i adjusted the bolt that limits turning
Reply 0
Nov 13, 2015 | 05:40 PM
  #14  
There are stock 8" wheels.

WJ LCA solves the rubbing problem.
Reply 0
Subscribe
Currently Active Users (1)