I finally finished my rear bumper re fab. I didn't really take picutres along the way but here is the finished product. I bought this bumper off the owner of ok 4wd. He had it on his tj and racked it on a tree. I saw it sittin in the back and asked him what it was all about and he said 50 bucks and its yours. Best 50 bucks I ever put into the jeep. I made some mounts out of 2x4 tube steel. These tie right into the unibody. Here's the pics. Tell me what ya think

 

what does it look like on the jeep?

 

All I have right now is a pic of the first fit. It looks really good and I will have more when I finish it. I needs nut strips built

 

I wanna see more of this build!!

 

Looks good but we def. need some pics of it installed.

 

+1

Can't make a good judgement til its seen on the truck!

 

Just a teaser this was the first fit to figure out the location of the two supports

 

It looks a little wide but for 50 bucks, what a score. Good Job

 

It will be a little wide but then I finish/install the tube fenders it will be like a jeep wide body kit haha

 

Plus since you can weld, you could just trim them up and re cap them on the sides to tuck it in more but i cant wait to see what you come up with.

 

Before I even got down to the part where you were talking about a wide body, I was thinking, "Hmm bet you could make some tube fenders, tie them into that bumper, and stuff some serious rubber up in there!

 

 

i dont think it looks to bad...i cant imagine that fitting on a tj tho or looking right on it at the least?

 

That's not a TJ bumper that's a JK bumper..

 

Possible.