lower control arm mounts - upper and lower reinforcement
#1
Senior Member
Thread Starter
lower control arm mounts - upper and lower reinforcement
has anyone done this type of work before and if so can you share photos? I am finding that the upper mounts to my lower control arms are getting cracks and are disforming a bit and would like to weld on reinforcements to beef it up. My initial thoughts are to cut a few pieces of metal and weld them up against the buckets and also against the unibody but thought i would check with you guys first.
I was not sure where the best place to post this but I figure you guys are the ones most likely to done this before.
I was not sure where the best place to post this but I figure you guys are the ones most likely to done this before.
#2
Moderator CF K9-unit
Join Date: Apr 2012
Location: Alaska
Posts: 5,842
Likes: 0
Received 9 Likes
on
8 Posts
Year: 2000 sport
Model: Cherokee (XJ)
Engine: New 4.0l from s&j engines
has anyone done this type of work before and if so can you share photos? I am finding that the upper mounts to my lower control arms are getting cracks and are disforming a bit and would like to weld on reinforcements to beef it up. My initial thoughts are to cut a few pieces of metal and weld them up against the buckets and also against the unibody but thought i would check with you guys first.
I was not sure where the best place to post this but I figure you guys are the ones most likely to done this before.
I was not sure where the best place to post this but I figure you guys are the ones most likely to done this before.
You might have to fab something up.. Maybe use a skid for the bottom mount and make it work for the top mount somehow.
https://www.quadratec.com/products/12561_100.htm
Thread
Thread Starter
Forum
Replies
Last Post
1ATony
Vendor Showcase
3
04-05-2012 02:44 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)