lower control arm mounts - upper and lower reinforcement
has anyone done this type of work before and if so can you share photos? I am finding that the upper mounts to my lower control arms are getting cracks and are disforming a bit and would like to weld on reinforcements to beef it up. My initial thoughts are to cut a few pieces of metal and weld them up against the buckets and also against the unibody but thought i would check with you guys first.
I was not sure where the best place to post this but I figure you guys are the ones most likely to done this before. |
Originally Posted by jon-d
(Post 3534772)
has anyone done this type of work before and if so can you share photos? I am finding that the upper mounts to my lower control arms are getting cracks and are disforming a bit and would like to weld on reinforcements to beef it up. My initial thoughts are to cut a few pieces of metal and weld them up against the buckets and also against the unibody but thought i would check with you guys first.
I was not sure where the best place to post this but I figure you guys are the ones most likely to done this before. You might have to fab something up.. Maybe use a skid for the bottom mount and make it work for the top mount somehow. https://www.quadratec.com/products/12561_100.htm |
how about drop brackets? or will i have the same problem as i do now?
|
All times are GMT -5. The time now is 11:13 AM. |
© 2024 MH Sub I, LLC dba Internet Brands