Ok guys im about to trim my front and rear Fenders and I plan on taking a lot out well as much as I can.. Any pictures or suggestions would be help full. I still want it to look clean not a hack job. I'll post a picture so you can see what im working with..

 

This is not fabrication Use the search feature!

 

Cut him some slack. It looks like he fabbed his own snorkle at least

 

Here's mine. Just used a angle grinder with cut off wheel on front and rear. The front will soon be higher.

 

Careful when cutting back fender on drivers side, wiring harness is there.

 

I traced a line around the outside of my stock fender flare and cut there.

That's been more than enough for 35's and 5"s of lift for the longest time.

 

Same here, just used a white paint pen. Running 32s without a lift atm.

If you can get your hands on a pair of electric shears make it a really quick job for the front and they leave a clean line.

 

im liking the ***** g on the filler door

 

Willie g? Haha it's a ballistic fab skull

 

Did mine last week. I cut a lot out of the front!

 

I'll be doing my front that high soon Maybe tomorrow? I'll see haha

 

That is a harley davidson willie g skull. Ballistic fab must have just copied it. Look on the Harley website. Anyways i am digging it.

 

They are similar in that they are both skulls.





Anywho, OP, more isn't always better unless you like that hacked up looks.

 

Damn ! I never knew that. But that's sweet. And
Thanks

 

4.5 and 33s?