Well here is what I started thought I would share and I can do a full measurement write up if there is interest but if not here are some pictures.

 

nice welds. i cant wait to see it finished with a winch in it

 

I like it so far, the winch will be nicely tucked out of the way. lol and nice diff!

 

VERY interested in the measurements! Keep up the good work. This is just the write up I have been looking for.

 

looks to be a good start.

 

is it only bolted on by the three stock bolt locations?

 

x2!!!!!!!!


i hope there is ALTEAST 6 BOLTS PER SIDE


i would use ALL 7 holes perside

like this:

that is the template that i used to make my mounts (out of 1/4" steel)

 

That is sweet. Looks strong, great weld, and excellent design.

 

great start hope to get mine goin when vacation is over...

 

Those are aj's offroad bumper brackets so they tie in with more than three bolts but since i have to take off the bumper to finish weld and put it back on to make sure stuff lines up so i only bolted it in three bolts right now to make things easier.....Also I will do an in depth write up after I get my notebook back I left it over at a friends so I will do an total write up when I am all finished up....Thanks for the compliments.

 

Nice lookin welds.

 

heres mine

 

Well I got a little more work done and added the start of the side pieces hope you enjoy. I also added a mini skid to the bottom to give it a more finished look and act as a mini skid lol will show how i did this a little better later on.

 

That's a pretty cool lookin bumper brother. Nice work

 

that is exactly how I want mine to look when done. Small and strong. Looks great