Johnny9Inches

I made this little tread because I couldn't find any information and had to go about it on my own. I swapped my 0331 head for a 0630 head. As I thought I had a crack in the head, having it fluxed to make sure.

Not to hard to come up with but still every little bit helps.

I used a sheet of 12x12 Aluminum from HD, marked my cuts and fold lines, folded it three times over it's self so it was a little stronger.


After I cut the first one and folded it I realized that they were to long, They only need to be about 4" long. After I cut them to size I marked for the first hole, the one that is going on my valve cover bolt and drilled it out. I used 1/4" flat washers, and 1/4" Hex Nuts to fasten the aluminum to the bolt. I then bent it over the the hole on the Coil Pack. Market my second hole and drilled that out as well. Now bent and painted....


Once painted I first ran the old bolts threw the brackets and then threw the Coil Pack, I used 1/4" flat washers and 3/8" hex nuts to fasten to the bottom of the coil pack. Then bolted it down to the valve cover.


Hope this helps some people who were as lost as I was, please if you reply try not to post what I posted so we dont waste the thread page on the same image over and over.

If you have any questions don't hesitate to PM me.