I drove for about half A-day with my drive shaft removed along with gutting the differential and removing both the axle shaftsAnd now my Wheel hub looks like this does anybody have any advice or information considering I'm assuming that the wheel cylinder is


most likely shot because of that now

 

The inner part of the unit bearing needs the stub shaft to hold it together

 

That's what I was thinking also, so that wheel hub isn't messed. I was going to replace it today with the Inner shaft in there but I didn't know if the will was still good or not.

 

It probably is. If it starts making noise you will know

 

Awesome I set a block of wood on top of it and hammered the **** out of the wheel hub back together so there wasn't any gap. Well shoot hopefully my wheel doesn't break off later today 🤞
And I should probably put the long shaft back in also I'm assuming