u joint help
not sure if this is right place if not sorry I have a 93 jeep Cherokee country am trying to replace u joints on front drive shaft it has one on back got that off the other is in like a cv joint there r two back to back I can move the ujoint up and down but c no way to remove can anybody help me thanks in advance
Old fart with a wrench
Joined: Nov 2010
Posts: 14,398
Likes: 741
From: Manlius, east of Syracuse, NY
Year: 2000 XJ Sport & WJ Laredo
Model: Grand Cherokee (WJ)
Engine: 4.0L
Welcome to CF!
That double-carden joint can be replaced. I believe there are snap rigs on the inside of the caps that can be removed with a screwdriver and hammer. There is a ball and socket on the center section that can also be replaced. The other option is to take it to a driveshaft shop for repair or buy a reman shaft. Your choice.
I also think the double-carden should be on the transfer case end.
That double-carden joint can be replaced. I believe there are snap rigs on the inside of the caps that can be removed with a screwdriver and hammer. There is a ball and socket on the center section that can also be replaced. The other option is to take it to a driveshaft shop for repair or buy a reman shaft. Your choice.
I also think the double-carden should be on the transfer case end.
Last edited by dave1123; Oct 17, 2014 at 06:30 PM.
Old fart with a wrench
Joined: Nov 2010
Posts: 14,398
Likes: 741
From: Manlius, east of Syracuse, NY
Year: 2000 XJ Sport & WJ Laredo
Model: Grand Cherokee (WJ)
Engine: 4.0L
Someone must have installed it backwards. That's why I mentioned it. It sees much less abuse on the t/case end. It's steady, not moving up and down all the time.
I took it to a driveline shop to have it checked the shft was wore out knuckle had a lot of were so I got one from a used auto parts place it is smooth and looks good will get it in this week and hope it works thanks for the info
Thread
Thread Starter
Forum
Replies
Last Post
cpnwrench
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
14
May 5, 2024 12:21 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)



