Transfer case problem
Thread Starter
Newbie
Joined: Aug 2022
Posts: 8
Likes: 1
From: Bavarian
Year: 1998
Model: Grand Cherokee (ZJ)
Engine: 5.2
Transfer case problem
I did a overhaul for my TC 249. And today i cant screw it on the trans. it is a gap from about 10 mm between the cases. After some measurements and tries it looks like the shafts does not fit.
The output shaft from the Trans is 11 mm out of the case flange.
And the input shaft is about 35 mm out of the case flange and has a 35 mm internal gear.
that meand the output shaft is touching the closed needle bearing in the input shaft of the TC before the cases are together.
What can be wrong?
The case was in the jeep. no parts like the input shaft are changed, only bearings and seals and the VC.
The input shaft is fixes with the retaining ring.
comes the output shaft from the Trans out???
The output shaft from the Trans is 11 mm out of the case flange.
And the input shaft is about 35 mm out of the case flange and has a 35 mm internal gear.
that meand the output shaft is touching the closed needle bearing in the input shaft of the TC before the cases are together.
What can be wrong?
The case was in the jeep. no parts like the input shaft are changed, only bearings and seals and the VC.
The input shaft is fixes with the retaining ring.
comes the output shaft from the Trans out???
Thread Starter
Newbie
Joined: Aug 2022
Posts: 8
Likes: 1
From: Bavarian
Year: 1998
Model: Grand Cherokee (ZJ)
Engine: 5.2
I did a overhaul for my TC 249. And today i cant screw it on the trans. it is a gap from about 10 mm between the cases. After some measurements and tries it looks like the shafts does not fit.
The output shaft from the Trans is 11 mm out of the case flange.
And the input shaft is about 35 mm out of the case flange and has a 35 mm internal gear.
that meand the output shaft is touching the closed needle bearing in the input shaft of the TC before the cases are together.
What can be wrong?
The case was in the jeep. no parts like the input shaft are changed, only bearings and seals and the VC.
The input shaft is fixes with the retaining ring.
comes the output shaft from the Trans out???
The output shaft from the Trans is 11 mm out of the case flange.
And the input shaft is about 35 mm out of the case flange and has a 35 mm internal gear.
that meand the output shaft is touching the closed needle bearing in the input shaft of the TC before the cases are together.
What can be wrong?
The case was in the jeep. no parts like the input shaft are changed, only bearings and seals and the VC.
The input shaft is fixes with the retaining ring.
comes the output shaft from the Trans out???
Thread
Thread Starter
Forum
Replies
Last Post
bighouts5591
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
6
Sep 18, 2013 02:33 AM
Rumled
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
9
Oct 26, 2012 12:03 PM
mashbolt
Stock Grand Cherokee Tech. All ZJ/WJ/WK Non-modified/stock questions go here!
5
Aug 21, 2012 06:24 PM
ny_driver
Stock Grand Cherokee Tech. All ZJ/WJ/WK Non-modified/stock questions go here!
14
May 17, 2011 10:40 PM
jake149
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
2
Jun 17, 2010 08:56 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
