Hey all, new guy here! I just picked up a 2000 Grand Cherokee Limited 4.7L Select Trac. Here’s my question/problem: when I engage 4wheel Full it goes fine until I stop then it acts like its in neutral. I have to put it 4w part time, 4lo, or 2wd to move. Any ideas? THANKS!

 

Does it have a front driveshaft?

 

Ding ding ding! We have a winner! Now to figure out why its missing and which one I need.

THANKS

 

So, went to the local pick a part and they actually had two of the shafts I need (cv joints on both ends) and both were bent when they picked them up with the forklift. Thanks again for the quick suggestion. It never occurred to me to look and see if the drive shaft was there.

 

How do I get my 🚘🚀 Jeep Grand Cherokee out of 4 wheel drive?
To shift from 4-Wheel Drive Low to 4-Wheel Drive High, with the vehicle at speeds of 0 to 3 mph or 0 to 5 km/h, the ignition switch in the On/Run position or the engine running, shift the transmission into Neutral, and push the 4-Wheel Drive Low button once.

 

It sounds to me like you've got 247 Quadradrive so you don't. It stays in 4wd all the time. Sucks, don't it?