Recently bought a 94 Jeep GCL ZJ 4.0L I6 w/90k.

Working out small things.

Had some thumping at rear (slow, rough road), re-hung exhaust a little better, looking into hatch bumpers (but that's another story).

Noticed front exhaust hanger is similar to rear - bent rod (tube?) welded in front of cat to pipe and bolted to an offset rubber hanger.

Short of welding or changing major components (no leaks) is there a standard existing hanger that would bolt around pipe and bolt into the hanger (to the side of pipe). I can picture one (as on engineer) but haven't seen one out there yet.

D

 

And you probably won't see one either. Nobody would buy one if all it takes is to weld a piece of round stock to the pipe. I once saw a truck with 2 muffler clamps holding a piece of steel to the pipe, but that was tacky.