Does anyone have any tips on the best way to replace the bushings on the trac bar?

When I replaced the bushings in my rear track bar I used a dremmel with a drill bit and drilled a bunch of holes in the rubber until I was able to remove the center. Then I cut through the shell in two places and pulled it out. You could have a shop press them out, it would be way easier.

I can't get the damn shells out

torch them out just really smokey

Got them out but the Kevin's off road kit doesn't fit, seems way too big... And when I got the two parts in the metal sleeve for the bolt isn't snug

this a factory bar...

Yea

dont think that fits stock bars just certain aftermarket one...

Well I got mine to fit!!!

they dont fit here

but they do here ...

I beat the living **** out of them till they did

Ok so here's the problem. The bushings actually fit nicely, but the sleeve for the bolt has play in it. How would I fix this issue?

Try getting a washer or two in between the bushings!

The bushing are fitting fine. The sleeve seems like its too small for the bushing, I need one that fits snug.