97 replaced pcm now in no run mode
Hey everybody! Have a 97 grand Laredo that had the infamous stalling issue, got to the point to where it would not fire at all. Threw a oem crankshaft sensor in it for good measure and that wasn't it. Found a wrecked 97 and got the pcm out of it and it fired right up.. dies in 2 seconds. I assume I have vtss because there is the red led on top of the dash, but it's never worked since I got the vehicle. I get no chirp of the horn or blinking lights when I lock with the fob or manually and I've never seen the led blinking. I've tried manually unlocking the passenger door, no go. I'm not sure how to disarm it if I can't get it to arm in the first place. Open to suggestions.
Thanks,
Izzy
Thanks,
Izzy
Not much action over here. Anyway to close the thread, the bcm in my cherokee had been modified by the dealer and security was disabled. I took the bcm out of the donor jeep and it runs again. Note to anyone else who goes this route, your odometer will read the mileage of the vehicle you pulled the bcm out of.
Thread
Thread Starter
Forum
Replies
Last Post
Blackcherokee290
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
28
Jan 8, 2025 11:36 PM
95cherokee89
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
59
Oct 16, 2015 03:17 AM
jghaenlein
Stock Grand Cherokee Tech. All ZJ/WJ/WK Non-modified/stock questions go here!
8
Aug 27, 2015 07:07 AM
relcock
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
0
Aug 26, 2015 11:16 PM
CCKen
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
3
Aug 20, 2015 08:07 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)



