losdog

My 94 gc with 247k miles seems to lose OD and 1st gear when I exceed 45mph aprox. When I reach stoplight I will restart motor and everything is fine until I exceed 45mph. I replaces the transmission speed sensor on the transmission but still same thing. I'm going to replace the throttle position sensor next. Any ideas guys? So far I read it could be either of the 2 before mentioned parts as well as governor solenoid, tcu, but I'm starting with the cheapest parts first. Please help

wingless

Which engine / transmission?

Have the fluid pressures been measured per the FSM? Have the intact-transmission FSM tests been performed? Has the pan been dropped, what is the fluid condition / contamination level?

losdog

4.0 auto full time 4 wd

dave1123

My FSM points to the governor circuit malfunction or linkage adjustment. Check the trans codes with a DRB II scan tool.

losdog

I did pulled error code 23. Clutch solinoid?

dave1123

Yes, my trans manual says "converter clutch solenoid output." 45 mph is about when the converter goes into lock-up.

losdog

Well. Already ordered the tps but can't find part called converter clutch solenoid. Rock auto and am auto parts have no such thing??

dave1123

rockauto.com, ACDELCO 2141767 {#19138851} Professional
Trans code 42re; TCC Solenoid w/Harness; Transmission Control Solenoid; $74.79

That's if you have the 4.0. That's what I looked up.

losdog

That's the same as converter clutch solenoid? OK gonna order right now. Thanks man! I almost ordered the overdrive lock up solenoid

losdog

Figured it out guys!!!! Broken spring in the 3 4 accumulator piston. Went to pull n save and every 42 and 44re transmission I opened had broken spring. Seems like a common problem?? I cant believe im only obe with this situation?Thanks for all your help

dave1123

That's easy enough to check rather than junking the jeep because of a bad transmission. Good catch! Something to remember.

BTW, TCC = torque converter clutch.