4x4 linkage
#6
Old fart with a wrench
According to my book, the linkage should be adjusted in NEUTRAL. Raise to rear of the vehicle, loosen the sliding trunnion on the linkage and make sure it slides. Place the transfer case shift lever in neutral and verify that it's in neutral by turning the driveshaft with the trans in park. Place the console lever in neutral and tighten the sliding trunnion. Verify you haven't moved the shift lever or the transfer case lever out of neutral and then test drive.
Should do you proud.
This is for prior to 99. In 99, they went to a cable. I believe the only way to adjust the cable is to bend the cable support bracket under the car.
Should do you proud.
This is for prior to 99. In 99, they went to a cable. I believe the only way to adjust the cable is to bend the cable support bracket under the car.
Last edited by dave1123; 02-04-2013 at 11:34 AM.
Thread
Thread Starter
Forum
Replies
Last Post
cmcl3m0r3
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
4
05-21-2019 02:38 PM
jeepdewd
Stock Grand Cherokee Tech. All ZJ/WJ/WK Non-modified/stock questions go here!
20
08-02-2016 01:29 AM
LittleRed94
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
5
10-06-2015 08:09 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)