adusting zj 4wd linkage
#1
Newbie
Thread Starter
Join Date: Dec 2012
Location: ILLINOIS
Posts: 26
Likes: 0
Received 0 Likes
on
0 Posts
Model: Cherokee
Engine: 4.0
adusting zj 4wd linkage
guys. tips,ideas on adjusting the 4wd linkage in 96 zj with 5 1/2 inch lift?
I cant get her to go into 4 low... but everything else yes. inside the jeep does not line us t0 2wd when its actualy in 2wd.
I cant get her to go into 4 low... but everything else yes. inside the jeep does not line us t0 2wd when its actualy in 2wd.
#2
Old fart with a wrench
Read my previous post. I just when through this with skenney97zj.
Last edited by dave1123; 02-04-2013 at 11:38 AM.
#4
Newbie
Thread Starter
Join Date: Dec 2012
Location: ILLINOIS
Posts: 26
Likes: 0
Received 0 Likes
on
0 Posts
Model: Cherokee
Engine: 4.0
According to my book, the linkage should be adjusted in NEUTRAL. Raise to rear of the vehicle, loosen the sliding trunnion on the linkage and make sure it slides. Place the transfer case shift lever in neutral and verify that it's in neutral by turning the driveshaft with the trans in park. Place the console lever in neutral and tighten the sliding trunnion. Verify you haven't moved the shift lever or the transfer case lever out of neutral and then test drive.
THIS ^^^^^^^^^^^^ is the correct way to do it as dave has posted. thanks
THIS ^^^^^^^^^^^^ is the correct way to do it as dave has posted. thanks
Thread
Thread Starter
Forum
Replies
Last Post
cmcl3m0r3
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
4
05-21-2019 02:38 PM
Freakn
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
52
10-04-2015 06:34 AM
sjm79902
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
2
09-30-2015 11:14 PM
shadowmoses
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
8
09-30-2015 06:51 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)