project: xjeep
Thread Starter
Seasoned Member
Joined: Apr 2009
Posts: 344
Likes: 0
From: fresno, ca.
Year: 1991
Model: Cherokee
Engine: 4.0 liter h.o.
i am currently working on a new sponsorship right now to get some cool stuff for my jeep. right now i am working on getting three glowshift gauges for my metal dash that im going to build. check out my sponsor page using the link on the last post.
Last edited by 91xj; Jul 13, 2010 at 03:31 AM.
Thread Starter
Seasoned Member
Joined: Apr 2009
Posts: 344
Likes: 0
From: fresno, ca.
Year: 1991
Model: Cherokee
Engine: 4.0 liter h.o.
i painted the bumper od for now because that is the only paint i had. i also went this morning and got the 2 rear windows tinted because my jeep got broken into again
Thread Starter
Seasoned Member
Joined: Apr 2009
Posts: 344
Likes: 0
From: fresno, ca.
Year: 1991
Model: Cherokee
Engine: 4.0 liter h.o.
thats all it will let me post right now. the site thinks im posting duplicates, so i will put up the others later. i thought some of you might enjoy these pictures.
Thread Starter
Seasoned Member
Joined: Apr 2009
Posts: 344
Likes: 0
From: fresno, ca.
Year: 1991
Model: Cherokee
Engine: 4.0 liter h.o.
Thread Starter
Seasoned Member
Joined: Apr 2009
Posts: 344
Likes: 0
From: fresno, ca.
Year: 1991
Model: Cherokee
Engine: 4.0 liter h.o.
thanks for all the nice comments guys. i finally had the extra cash to get my front driveline extended. i have four wheel drive again. i havent had that since before my lift kit because when i installed the front axle, i just slapped in my carrier and pinion so the gears would match. at first it was okay. then my pinion bearing went out and i had a lot of slop. i replaced the bearing and race and shimmed correctly and now im good to go


