94XjSport94

Use a diode in series (anode and cathode on right ends) on the blue/ pink stripe wire from the ECU. Only allows current to flow one way and no more CEL. RadioShack, 12v diode.

cleenrob

Does this go on the relay side or the ecu side of the switch? Is there a particular diode to use? I'm not the most electronicly gifted

94XjSport94

12v diode, that's all. Just right at the ECU. I'll take a pic after work

cleenrob

Just did my 703 injectors

cleenrob

Started to work on doorless but my dremel just burnt out :/

cleenrob

Just a pic of when she was stock

armymedic120

I burned two doing mine they just don't make them like they used to

cleenrob

Jerks. Lol

cleenrob

man these injectors have made quite the difference!!! idle and acceleration seem way smoother and healthy now!! i should have done them a long time ago

cleenrob

Well I finnally got around to installing my new temp sender for my temp gauge and the engines reading 215ish now.. crap..

So when I get home I'm gonna order a flowkooler water pump,robertshaw 195 thermostat, and a ported/ hi flow t-stat housing probly from hesco and flush the radiator/ block with new coolant.

And I've got a bad u joint on the passangers side shaft so I figure ill do new u joints on both sides and install some new hubs while I'm at it

So my current list as of now:

- flow kooler pump
- new t- stat
- ported t-stat housing
-new u joints
-136 amp alt and cables
-trans cooler
-29 spline 8.25 swap ( with 4.56s and zj disks)

94XjSport94

Don't waste money on that thermostat housing. Search around and see hi flow housings are a waste

cleenrob

Soldmy wheel spacers!

cleenrob

And ordered my flow kooler pump, t stat and high flow t stat housing! Will probly do those next week after it all gets here

cleenrob

i also think im going to redo all my plasti dip with monstaliner cause the hatch dip just got pressure washed off

cleenrob

Picking up and IRO hack n tap with all bits in cludedoff