Project Black Betty ....Tons of Pics
#46
Seasoned Member
Thread Starter
Join Date: Jan 2010
Location: Birmingham Alabama
Posts: 251
Likes: 0
Received 0 Likes
on
0 Posts
Year: 1988
Model: Cherokee
Engine: Renix
Project BLACK BETTY
Homemade Bar Pin eliminators using the rear swaybar mounts
They and about and inch to the shock length
They and about and inch to the shock length
#47
Seasoned Member
Thread Starter
Join Date: Jan 2010
Location: Birmingham Alabama
Posts: 251
Likes: 0
Received 0 Likes
on
0 Posts
Year: 1988
Model: Cherokee
Engine: Renix
Project BLACK BETTY
I tool the bar pins out, cut the ends off and drilled them out to half inch.....then I pressed them in the shock and used a half inch bolt to go through the bar pin eliminator
#49
Seasoned Member
Thread Starter
Join Date: Jan 2010
Location: Birmingham Alabama
Posts: 251
Likes: 0
Received 0 Likes
on
0 Posts
Year: 1988
Model: Cherokee
Engine: Renix
Project BLACK BETTY
Rear lift complete.....I threw the stock 235/75-15 tires back on to make it easier to lift the front off the ground to install the front lift....kinda a bad angle i will post another pic when i get a chance
#55
Seasoned Member
Thread Starter
Join Date: Jan 2010
Location: Birmingham Alabama
Posts: 251
Likes: 0
Received 0 Likes
on
0 Posts
Year: 1988
Model: Cherokee
Engine: Renix
Project BLACK BETTY
Ok the tie rod was frozen and could not be adjusted to align the front end I tried everything Torch...penetrating spray .......brut force....nothing worked ....so I went to pull a part and got one off a grand cherokee that looks almost new for $7 and final got the front end aliened....Pic of bad tie rod
#56
Seasoned Member
Thread Starter
Join Date: Jan 2010
Location: Birmingham Alabama
Posts: 251
Likes: 0
Received 0 Likes
on
0 Posts
Year: 1988
Model: Cherokee
Engine: Renix
Project BLACK BETTY
Rubicon Express Lower Control Arms .....I also have some JKS bar pin eliminators on the way ....not installed in this pic