Can you snap a few more pictures of the back bumper. I'd like to see how it lines up with the rear quarter panel. Thanks!

 

It lines up pretty well. One side is a bit low but I have not had time to get under there and align it some more. I have shackle relocation brackets and I had to trim/grind them some to get it up as high as it is. Without the brackets, it would line up pretty nice. I get some pics tomorrow as I put the header and down pipe on.

 

Thanks man. Did you have to do any extra drilling? Drop the gas tank? Overall, how hard was the install?

 

No drilling nor drop the tank. It's pretty much a direct bolt on.

 

Awesome. Thanks man.

 

Pics of the bumper alignment.

It is backed into the garage and I cannot get a full shot of the whole bumper. Like I said, it lines up perfect on one side but I have to get under there and trip the shackle relocation bracket on the other side so it can go up about 1/3" to be perfect.

 

Decided to pull the head to get new springs, valves, and guides as well as resurfaced. APN header came in today.

 

I dropped they cylinder head off today to have it reworked. Then this afternoon I prepped the block for the install.

 

Alright. Head is on with new springs, guides, cleaned up valves, and resurfaced deck. Shop said it was a little warped, but not a lot. Header and intake manifold are one. Jeep is running nice now. Lot more pep with all of the new and redone stuff. It is breathing a lot easier now.

 

New horns that really work. Very loud and might make people actually get out of the way.

 

New procomp 3.5" full leaf springs added.

 

Stock vs old stance vs current. Look at the back tires and you can see how much the old AAL OEM springs were sagging.

 

Love that paint job!

 

Some more.

 

Thanks. Maaco special.