At least you did not have to put in a heater core. Done mine this week and a grand the week before.



But my the with new heater cores the heat will run you out of there!!

And it takes about 5min to warm up in the morning.

 

I HAVE LIGHTS !!!! cleaned up the corrosion on the connecter plugged it back in and still no lights, Got to looking at it and discovered a blue/red wire that wasn't hooked up to anything , looked at the plug and saw it came out , popped the pin out hooked the wire back in , hooked the plugs back together and I have lights working as they are suppose to

 

Did that come undone at the harness connector or at the headlights

 

at the connector. blue / red wire

 

Finally made a video out of the dash cam video i got at the dunes last oct.
Make sure you change the quality!

 

No go on the video.

You broke copyright laws. Probably choice of music.

 

every thing works fine for computers. but it doesnt work on mobile devices for some reason

 

When I clicked on it, it says " this video has been blocked for copyright infringement."

 

Ok I'll look into it thanks

 

You were right. I watched it on my PC and it was just fine. Don't know why it said the other on my phone?

Anyways, great vid and music. Thanks for sharing

 

Okay maybe someone to point me into the right direction here, has anyone seen or done any homemade sway bar drop mounts?? or the BPE?

 

very easy to do, use c channel or bar extensions. But honestly I would throw the sway bars in the trash. They don't do much at all in my opinion.

 

well that what I though but my jeep right now is my dd cause the cummins tran is out, how low does the piece have to be down from the unibody?

 

how soon do you need them? i have a set for the front that i didn't use on my 3" r.c.

 

the brackets are pictured in the middle. also i think they have the directions for them. i'd have to go look in the garage later.

http://www.roughcountry.com/jeep-sus...-kit-670x.html