What did you do to your XJ today??
Senior Member
Joined: Oct 2009
Posts: 940
Likes: 0
From: Oly, washington
Year: 1989
Model: Cherokee
Engine: 4.0 str. 6
i would if i had a trailer, big enought to park the jeep inside and work on it, motorhome to tow it and two more freinds with the same set up
Newbie
Joined: Feb 2009
Posts: 22
Likes: 0
From: South Jersey
Year: 1999
Model: Cherokee
Engine: 4.0; air raid throttle body spacer; k&n air filter
i installed a tc drop because of vibrations i was experiencing after i put my rc 3" lift on a couple of weeks ago. I am thinking about getting a dynomax turbo exhaust kit and was wondering what kind of cold air intake would be good to install with it
CF Veteran
Joined: Nov 2008
Posts: 6,989
Likes: 4
From: Oak Harbor, WA.
Year: 1987
Model: Cherokee
Engine: 4.0 liter RENIX I-6, DIY Cold Air Intake, 2.5 FM Exhaust, 3 Core Radiator
I have been taking lots of pics. Can't wait to get home and download them onto the computer and see how they really turned out.
CF Veteran
Joined: Sep 2008
Posts: 1,053
Likes: 0
From: Ft. Lewis, Wa
Year: 1987
Model: Cherokee
Engine: 4.0
so i decided i would clean my rear drums out since the last muddy mess of a jeep run kind of caked everything. i took the first tire off and found a wonderful sight! my leaf spring centering bolts were sheared in half. this pushed the axle forward and loosened up my u bolts and totally messed up my pinion angle. i was shocked and then looked at the other side. the same story. so i dropped the axle down and pulled everything apart and found my shims to be in sorry condition. i ran down to TCs offroad shop and picked up some new 6 degree steel shims and centering bolts. then when i was putting the leafs back together with the shims i realized that i had lost a bottom leaf on one side... i now have six leafs on the driver side and five leafs on the drivers side... so she kind of sags now. but i got it all put back together but didnt get to drive it to test it out. now i am thinking that maybe my driveline wasnt bad? maybe just the shims messed up the pinion angle? i am going to test it out today.
Member
Joined: Nov 2009
Posts: 234
Likes: 0
From: Spokane, WA, USA
Year: 1993
Model: Cherokee
Engine: 4.0
More stuff frome The Bone-Yard...
Repaired & upgraded my battery cable ends, added a door buzzer, pockets on front door panels and installed pivot type wing windows... All and all, "Another good afternoon in the Man Cave"!
CF Veteran
Joined: Jul 2009
Posts: 2,471
Likes: 2
I rotated tires, fixed blinkers, tightened all trim, fixed arm rest lid, changed front brake pads, greased front end, relocated vac bottle to under hood , and put frint bumper back on. I ripped it off on my last outing. Now I have to change my diffs and tc fluids.
Thread Starter
CF Veteran
Joined: Jul 2008
Posts: 1,371
Likes: 2
From: Bonney Lake, WA
i toasted the shims i just put in a few weeks ago. so instead of getting new ones i went the permanent route. i pulled the rear end out, cut off the spring perches, mounted and welded new spring perches about 6 degrees forward. no vibes now 
