Ok yesterday in all my brilliancy went out wheeling a little bit alone. being 2wd i couldnt do much so i didnt try anything hard. But when through a dam sand/rock garden and got high centered on the crossmember. no damage to anything else tho.

I look down at it today and find this






the wire on the left side of the top picture is the connector.

My question is wtf is the connect to??

I have a 01' 2wd auto if that helps any

 

i dont see any pics just a red X

 

No picture


Do you have a CEL on?

 

X2

 

woops sorry guys i can see them. i'll fix it



I think its fixed now

 

Speedo? or the NSS or the backup lights?

 

X2

 

The speedo works. Whats the NSS? and the back up lights work fine. Remember its next to the tranny

 

NSS Neutral Safety Switch

 

Drivers side tranny?

 

Its not the NSS, thats a 6 prong plug (or maybe even more prongs)
Also, the jeep would not start if the NSS is unplugged

 

could be a wire to plug into a transfer case and since yours is 2wd it is unused

 

t-case indicator wire....2wd got em too..just not plugged in cause you dont have a t-case!!!

^^^guy above me beat me to it by 20 seconds!!

 

4WD Indicator Light Switch connector.

All XJ's have them. Even the 2WD models.

Just zip-tie it up out of harms way.

 

ok good. thats what i thought it might be. But it worried me. haha Thanks to everyone!