Valve Cover Grommets or CCV?
Thread Starter
Seasoned Member
Joined: Feb 2010
Posts: 272
Likes: 0
From: Pharr, Texas
Year: 1989
Model: Cherokee
Engine: 4.0L
My 1989 Jeep Cherokee came with the 4.0. On top of the valve cover from front to back it has a thick black hose then oil filer cap then a small black hose. The hose in the front has tons of silicon to hold it in place looks nasty. I want to replace the little rubber on the valve cover but what is it called? The autoparts store don't know what it's called either. And if you can post a pic so I know what it looks like.
Unofficial name- CCV grommet. The one in front is the same size as the one in the back and both cost less than $10 (both) at the parts store. The old ones will be brittle and usually will fall apart when removed. While you are at it, replace the rear 90* elbow. It has a small oriface that can get plugged over time and cause oil to be blown into the airbox. That fitting is only a couple of dollars as well and replacement of both it and the grommets can reduce the amount of oil that ooozes out on top of the valve cover. A little smear of fresh oil inside the grommets make installation easier.
Thread Starter
Seasoned Member
Joined: Feb 2010
Posts: 272
Likes: 0
From: Pharr, Texas
Year: 1989
Model: Cherokee
Engine: 4.0L
So then both of them look the same? The front and the back? Just need to get an elbow too it's all nasty. Gonna go to the junk yard to check if they have any there.
Senior Member
Joined: Jan 2010
Posts: 686
Likes: 0
From: Lake Orion, MI
Year: 2008
Model: Grand Cherokee
Engine: 3.0L CRD
i wouldn't get a used one, because you don't know if the elbows are plugged, and the grommets will most likely be weathered so bad you'll just damage them trying to pull them off an old junker. two elbows and grommets, as well as a new length of vent hose, shouldn't cost you more than $15.
Thread Starter
Seasoned Member
Joined: Feb 2010
Posts: 272
Likes: 0
From: Pharr, Texas
Year: 1989
Model: Cherokee
Engine: 4.0L
Well I took off the silicone and they are not the same size. The front one is bigger than the front one. The rear one has a small hole thw size of a screw driver. The front one is much bigger. Gonna have to go to the dealership see if they have the right one.
Trending Topics
TeamCherokee has TONS of really cool, hard to find parts...
http://www.teamgrandwagoneer.com/cgi...ing=0&catid=95
Hope this helps!
http://www.teamgrandwagoneer.com/cgi...ing=0&catid=95
Hope this helps!
Junior Member
Joined: Aug 2015
Posts: 64
Likes: 0
From: Mid-Michigan
Year: 1989
Model: Cherokee
Engine: 4.0l
My 1989 Jeep Cherokee came with the 4.0. On top of the valve cover from front to back it has a thick black hose then oil filer cap then a small black hose. The hose in the front has tons of silicon to hold it in place looks nasty. I want to replace the little rubber on the valve cover but what is it called? The autoparts store don't know what it's called either. And if you can post a pic so I know what it looks like.
::CF Moderator::
Joined: Aug 2011
Posts: 43,971
Likes: 1,579
From: Prescott, Az
Year: 1990
Model: Cherokee (XJ)
Engine: 4.0
Thread
Thread Starter
Forum
Replies
Last Post
Blue94xj
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
21
Oct 27, 2024 12:13 PM
cpnwrench
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
14
May 5, 2024 12:21 PM
ROCKRIDGE 4WD
Vendor Showcase
1
May 23, 2016 06:39 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)



