I relocated the vacuum ball thing after trimming my front fenders but now my cruise control doesn't work what happened? Is there a way to check this system or no?

 

are all the lines still plugged up to it? make sure the lines aren't pinched

 

As far as i can tell nothing is pinched

 

Where did you re-locate it to? try putting it back in the same spot or close to it and see if it works. i highly doubt its the place u mounted it though. mine stopped working after i had re-located mine and found out it was the button on the steering wheel. had to go to the dealership and buy a new one for like 30 bucks and it worked. was having bad connections

 

well i heard something about pressures and such everything worked fine before i relocated it it is attached to the same bracket as the coolant reservoir

 

Cruise control should work as long as the vacuum lines are hooked to the canister correctly. It should not make a difference where you relocated the cannister. Check the cannister with a vacuum gauge to make sure that it is receiving and holding vacuum. I am sure this will be an easy fix!

 

the ball or egg since thats more what it is shaped like is back where it goes but the cruise control is still not working i checked and double checked all the connections and when i get driving you can tell there is a vacuum cause the thing is full of air and sealed anybody know where i can get a switch and how hard it is to replace that

 

or is there a fuse in play somewhere?

 

i dont know if there is a fuse somewhere, most likely but u can buy the switch at the dealer. it comes off of the steering wheel with one screw holding it on.

 

right but i just dont know

 

what?

 

^^^^ if there is a fuse in the system or what is all i meant