Trans temp gauge sensor location question
01-30-2017, 05:41 PM
#18
Newbie
Join Date: Jan 2017
Posts: 2
Likes: 0
Received 0 Likes
on
0 Posts
Model: Cherokee
2000 Cherokee sport.
Ok, ive gathered some knowledge so far on the problems im having.i start the jeep and it runs for a little while and then cut out. It won't restart until about 20-25 Later. I started cheap and started cleaned ground sites then replaced the cps awhile back. Ive also changed out the MAP, IAC, ERG Perge. Fully cleaned the throttle body.....only other things that come to mind are fuel pump and regulator or injectors. I'm standing here looking at the engine twirling my thumbs.
01-30-2017, 05:41 PM
#19
Newbie
Join Date: Jan 2017
Posts: 2
Likes: 0
Received 0 Likes
on
0 Posts
Model: Cherokee
2000 Cherokee sport.
Ok, ive gathered some knowledge so far on the problems im having.i start the jeep and it runs for a little while and then cut out. It won't restart until about 20-25 Later. I started cheap and started cleaned ground sites then replaced the cps awhile back. Ive also changed out the MAP, IAC, ERG Perge. Fully cleaned the throttle body.....only other things that come to mind are fuel pump and regulator or injectors. I'm standing here looking at the engine twirling my thumbs.
01-31-2017, 07:36 AM
#20
CF Veteran
Join Date: Aug 2010
Location: Canton, MI
Posts: 8,357
Likes: 0
Received 82 Likes
on
67 Posts
Year: 1999
Model: Cherokee
Engine: 4.0
Ok, ive gathered some knowledge so far on the problems im having.i start the jeep and it runs for a little while and then cut out. It won't restart until about 20-25 Later. I started cheap and started cleaned ground sites then replaced the cps awhile back. Ive also changed out the MAP, IAC, ERG Perge. Fully cleaned the throttle body.....only other things that come to mind are fuel pump and regulator or injectors. I'm standing here looking at the engine twirling my thumbs.
I'm sorry but what does this have to do with trans temp sensor location?
You should start a fresh thread with this issue.
03-12-2021, 03:59 PM
#21
Newbie
Join Date: Mar 2021
Posts: 3
Likes: 0
Received 0 Likes
on
0 Posts
Model: Cherokee (XJ)
Hi I'm having trouble with my breaks changed the front calipers and brakes all the way around change the booster and master cylinder and bled it a couple of times on my 96 Jeep Grand Cherokee Limited for some reason when I crank the car the pedal goes to the floor but when the car is off it is stiff can somebody please help
03-12-2021, 06:07 PM
#22
Senior Member
Thread Starter
Join Date: Jan 2014
Location: Eustis, Florida
Posts: 886
Received 268 Likes
on
186 Posts
Year: 1996
Model: Cherokee (XJ)
Engine: 4.0
Well Travis....first things first.....one, this is a post from 2015 about where to install a transmission oil coolant temperature gauge sender. Two, it isn't about brakes. Three, this is for XJ model Jeep Cherokees and not Grand Cherokees. But with saying all that, you may want to start a new thread in the appropriate forum if you hope to get help. I do not have any information to help you with your described problem or I would give it and hope you take this advice as a voice of friendly help and that you find the answers your looking for.....good luck.
The following users liked this post:
JonRedcorn (03-13-2021)
Thread
Thread Starter
Forum
Replies
Last Post
tsconver
Stock Grand Cherokee Tech. All ZJ/WJ/WK Non-modified/stock questions go here!
3
09-13-2008 10:43 AM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)