Track Bar Alignment
This is may first post, though, I have enjoyed reading everyone's threads over the past few months...
I just installed my 2inch coil spacers and I'm trying to re-install the track bar, but the bar-to-axle-side doesn't seem to line-up.
(OK, so I didn't remove the bar-to-bracket-side! I figured I could get away with just dropping the axle-side!)
Anyone ever encounter the track bar NOT aligning after installing only coil spacers?
Any help would be appreciated! Thanks!
I just installed my 2inch coil spacers and I'm trying to re-install the track bar, but the bar-to-axle-side doesn't seem to line-up.
(OK, so I didn't remove the bar-to-bracket-side! I figured I could get away with just dropping the axle-side!)

Anyone ever encounter the track bar NOT aligning after installing only coil spacers?
Any help would be appreciated! Thanks!
do you have the jeep sitting on the ground or suspended on jackstands if its on jackstands you will never get it back in put it on the ground and see if that helps if not use a ratchet strap and pull the axle over till the trackbar holes line up
CF Veteran
Joined: Nov 2008
Posts: 7,874
Likes: 100
From: Northern Ontario, Canada
Year: 1990, 1999, 2000
Model: Cherokee
Engine: 4.0
it happens every time you remove the trackbar.
just get someone inside to turn the steering wheel slightly until the hole lines back up, then put the bolt back in and torque it to spec.
just get someone inside to turn the steering wheel slightly until the hole lines back up, then put the bolt back in and torque it to spec.
Thread
Thread Starter
Forum
Replies
Last Post
southfloridajeeps
Modified XJ Cherokee Tech
32
Mar 4, 2023 01:10 PM
Jooman07
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
0
Sep 21, 2015 12:13 PM
Sandyman
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
16
Sep 19, 2015 07:55 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)



