I have a 231 tc in my '99 that has a bent rear output shaft.(bent driveshaft did it on a goat) I have a '94 with severe cancer on the unibody but a good drivetrain minus the motor. Looks like the 231 in it has a cone on the output and the driveshaft for the rear is 1" longer. Could I bolt and play? Linkage looks the same. Swap rear shaft and tc since I have them? Or get the shaft replaced? Could use some help. I get #'s and spline counts in an hour and post, but everything looks the same between the 99 and the 94.