jeepman127

having trupuble dissconecting sway bar because piece contecting to link stuck the pins are not lining up and not moving or budging any help would be great

Deanxj97

Pic?

jeepman127

takin it now

jeepxj19

Spray them with dw40, and pull, try tapping the pin with a hammer

Deanxj97

I was gonna say the same, pb blaster. Maybe try raising it with a hi lift use the hammer and then lower it

jeepman127

best picture i can get phones dead

jeepman127

did that dosent work can these thiongs seize up idk what brand iit is came on the truck

Deanxj97

Ok I pictured it on the car. So the pin is stuck?

jeepman127

No the tube is stuck in the link to slide the pin in and out

jeepxj19

Oh so its off the rig, that makes it easyer. Clamp one end in a vice and grab the other end with some channel locks and pull, spray with some pb blaster or w.e, try clamping the link end in the vice then take a screw driver and slide it through the sleeve and pull while twisting.

Deanxj97

I thought it would be easier on your rig. Just us the hi lift and the weight of the axle should pull it out

jeepman127

i dont have a vice closest thing is a c clamp lol

jeepxj19

Do u have a pair of channel locks?