well i recentely purchased a sye kit and it was installed, and wen i hit the accelerator and i start moving the drive shaft still sounds like its binding up. i have 5.5 in lift and wen i take off the rear sags a little at take off so that makes me think that the ujoints on the driveshaft are binding up..any suggestions?

 

have you checked the universals in the front half shafts?

 

not yet but when i get home from schoole im going to do some lookin and mabe put it on the lift and try to figure this thing out cuz it really bothers me..and also wen i turn the key to start it, like wen it fries over it knocks like 3times and its coming from the same spot..this is a mystery to me

 

Hmm....well if it's knocking when you start it's something differnt. See if your drive shaft is rubbing on anything.

 

Check the centering ball inside the double-cardan joint. Mine was making a clicking sound under acceleration.

 

sry im kinda a newbie so what and where is the centering ball inside the double cardan joint?

 

I'm assuming your running a sye with a cv drive shaft. On the transfer case side drive shaft there will be 2 u-joints back to back. In the middle of the two u-joints there is a ball, spring, and a seal. this will help
http://www.therangerstation.com/Maga...rden_joint.htm

 

here is the address if that one didn't work.
http://www.therangerstation.com/Maga...rden_joint.htm