EDIT: ok, NEW problem I grinded a flat spot on the stud for my TC drop so I can put a crescent wrench on it and now it is working but it is just pushing the cross member down instead of extracting the stud.

 

can u cut it out ? just say then find one that will work till u get the right one

 

No, If I cut it out then how will I get the new bolt in there??

 

not sure i was just saying idk im going to be doing a tcase drop this week

 

small pipe wrench on the stud maybe if all you can get in is three bolt that will hold to go get a tool or what ever you need to to extract

 

Dont have a pipe wrench..

 

got a friend that could help

 

Everyone is at school..

 

well that sucks

 

EDITED the original post for the NEW problem.

 

let the crossmember down with a jack remove the stud

 

This, just lower the crossmember so its out of the way. BUY a pipe wrench and remove the stud. Usually 2-3" is enough, too much lowering and you start hurting the motor mounts.

Next time you are removing a stud, use 2 nuts and a regular wrench, it will be alot easier.