shims for cabin fuse block
Thread Starter
Newbie
Joined: Jan 2023
Posts: 17
Likes: 2
shims for cabin fuse block
95 cherokee country xj, 4.0 L, auto trans, Fuse #5 makes intermittent contact due to female clips on fuse block being too far apart (about 3X normal). PO's handiwork. I tried wrapping fuse stabs with aluminum foil, with no success. Looking for suggestions.
CF Veteran
Joined: Mar 2016
Posts: 3,816
Likes: 725
Year: 96
Model: Cherokee (XJ)
Engine: 4.0
a few ideas;
* using the existing fusebox and damaged female terminals, wire a fuse remotely
* Its normally possible to get the correct terminals from an electronics supply store, and you can usually pop the terminal out, solder the wire on, push clip back
* if the two above are not possible, cut needed wires and solder for remote fuse
* obtain a used fuse box
* using the existing fusebox and damaged female terminals, wire a fuse remotely
* Its normally possible to get the correct terminals from an electronics supply store, and you can usually pop the terminal out, solder the wire on, push clip back
* if the two above are not possible, cut needed wires and solder for remote fuse
* obtain a used fuse box
Thread
Thread Starter
Forum
Replies
Last Post
c1lonewolf
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
5
Dec 4, 2022 03:11 PM
Peer Plaut
Stock Grand Cherokee Tech. All ZJ/WJ/WK Non-modified/stock questions go here!
1
Jul 8, 2020 05:40 PM
cdf43
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
7
Nov 22, 2011 06:55 AM
duafacia
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
3
May 8, 2011 12:44 AM
wheeler
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
2
Dec 30, 2009 05:07 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)