My door isn't lining up properly. It looks like the Hinges where there welded to the body is sagging Any ideas? Mostly i need ideas on how to push them back into place. Cuz the other parts i'd have to take the doors off I get that Just don't understand how i'm goin to be able to push the hinges back in.

 

The door hinge needs to be welded if it's separating from the A-pllar.
Here's a good writeup to give you some insight http://www.go.jeep-xj.info/HowtoDoorHinge.htm

 

Thanks alot dude. It almost made it seem easy. haha

 

No problem. It shouldn't take too long to do as long as you have the right stuff. Have somebody pry on the hinge till it's flat against the A-pillar and tack weld it on. Remove the prybar and finish the weld. After that, just a coat of paint and your done.

 

What I did with my brother's jeep was open the door, stick a floor jack underneath the door and jack it up until the hinge is flat against the body. Kinda ghetto/shadetree, but it worked.