So I have already a RE 3.5 installed, and I am thinking of adding the Tera BB on top of it. Basically a 1" rear shackle and a 1.5" front spacer. Would also be adding some control arm drop brackets at the same time.

I am hoping to clear 33x10.5x15 Km2s.

Anyone do this yet?
Thoughts?
Opinions?
Etc???

 

I did the RE 3.5" which netted nearly 5", then simply saw-zalled the fenders. It didn't take any sawing for on the road only. I really could have gotten away with less cutting, but i didn't want any problems in the future or to really bend anything up by stuffing a tire.

 

You might be able to fit 33's, they may rub a little but should fit. If you flex much you may run into some issues. If you trim the fenders they will fit for sure but I dont know what your view is on that.

 

I thought the Tera-Flex BB was 1.5 front and rear, If it is 1.5 that would give you 5 inches and if you use bump stops the way you should 33s will fit a Cherokee before the 97 year model. It should fit the 97 and later models, I'm just not sure.

 

SkyJacker 3" with 33" tires factory bump stoping and Bushwacker flares. Minimal rubbing.

 

Been thinking about those Bushwacker flares, looks good.

 

33s will fit on a 3in lift no need for drop brackets or added spacers just a little cutting

 

This is about the exact setup I will have when finished. How much flex do you have? Can you get pretty aggressive on the trails without mashing the fenders??

 

You can. the only place i ever rub is on the end cap of the bumper. See how it sticks out past the flare a little?

 

Yeah I see that, my bumper doesn't go back quite that far so I should be good there. I thought my main worry would be the back side corner of the fender.. ?