ok i cant find the any write ups on it but then again i might be be looking in the right place. but there is a ways to over ride it. if someone could give me a gen brake down on how to do that i can figer it out.

 

i think you should be able to take the actuator off and move the shift fork over so its always engaged. the shaft siezes in the housing and the vacuum cannot overcome it so i'm think if you move it, it should stay put. or just jerry rig somethin to keep it there. theres snap rings that hold the shift fork in place on the shaft, maybe you just move'm around. just ideas, hope it helps.

 

well i got vacuum and i put it up on the lift here at work and it all4 spin. my light just does not come on. but its all good dont need a light realy.

if i could get it changed to a taggle that would not be to bad eather.