Problem starting
CF Veteran
Joined: Jan 2015
Posts: 1,469
Likes: 26
From: North canaan Connecticut
Year: 01, 99, 98, 98,98
Model: Cherokee
Engine: 4.0
Hey guys,
I have a 1996 Cherokee, I just replaced the floor pans which took me a couple months. I had the cables off the battery while doing installation. Today I finished and the jeep started right up. I replaced the IAC valve, TPS, and MAP sensor because I was having idle issues and on this forum sounded like one of these sensors. I took it around the block and when acceleraating there was a poping noise and ran very rough. Parked and shut it off for a couple mins and it refuses to start again. Won't even crank. Battery is brand new and measuring good volts. Also have a "GEN" light on which shows alternator but would that cause the motor to not turn over at all? Any ideas?
I have a 1996 Cherokee, I just replaced the floor pans which took me a couple months. I had the cables off the battery while doing installation. Today I finished and the jeep started right up. I replaced the IAC valve, TPS, and MAP sensor because I was having idle issues and on this forum sounded like one of these sensors. I took it around the block and when acceleraating there was a poping noise and ran very rough. Parked and shut it off for a couple mins and it refuses to start again. Won't even crank. Battery is brand new and measuring good volts. Also have a "GEN" light on which shows alternator but would that cause the motor to not turn over at all? Any ideas?
Thread Starter
Newbie
Joined: Dec 2016
Posts: 4
Likes: 0
Model: Cherokee
Hey guys figured out the problem was the NSS on the tranny, I no it's dirty and needs to be cleaned and or replaced but, I can't seem to get it off the shaft on the tranny and using the bolt as a fulcrum to get it off just starts stripping the threads. Also I know it was this because I moved it enough to get whatever gunk out from stopping it and it started. Any ideas how to get it off?