Pricing and axle swap questions
#1
Seasoned Member
Thread Starter
Pricing and axle swap questions
How much is a reasonable price for a Full-Floating 14-bolt out of a CUCV with 4.56's and a detroit locker?
What are some good options for the front of my XJ? I plan on overbuilding my rig and then as time goes by make it bigger and bigger, without worrying about strength problems. I have been contemplating a D60, but their price is what is holding me back.
Any input will be greatly appreciated.
What are some good options for the front of my XJ? I plan on overbuilding my rig and then as time goes by make it bigger and bigger, without worrying about strength problems. I have been contemplating a D60, but their price is what is holding me back.
Any input will be greatly appreciated.
#2
Registered Users
Join Date: Jul 2009
Posts: 850
Likes: 0
Received 0 Likes
on
0 Posts
Year: 91 with lots of 01' parts
Model: Cherokee
Engine: 01' 4.0L
you dont need that 14bolt for strength. 9 inch will do.
i have run a 14 bolt in a cherokee and drug it over everything!!
but if that axle is used...i would pay $500
new....maybe $800
but im cheap
i run a hp d 44 and 9 inch on 37's and only weak point is the u-joints. run ctms and you wont break em
i have run a 14 bolt in a cherokee and drug it over everything!!
but if that axle is used...i would pay $500
new....maybe $800
but im cheap
i run a hp d 44 and 9 inch on 37's and only weak point is the u-joints. run ctms and you wont break em
Last edited by xjbones; 10-13-2009 at 08:39 PM.
#3
Seasoned Member
Thread Starter
you dont need that 14bolt for strength. 9 inch will do.
i have run a 14 bolt in a cherokee and drug it over everything!!
but if that axle is used...i would pay $500
new....maybe $800
but im cheap
i run a hp d 44 and 9 inch on 37's and only weak point is the u-joints. run ctms and you wont break em
i have run a 14 bolt in a cherokee and drug it over everything!!
but if that axle is used...i would pay $500
new....maybe $800
but im cheap
i run a hp d 44 and 9 inch on 37's and only weak point is the u-joints. run ctms and you wont break em
Anyone else?
#4
Registered Users
Join Date: Jul 2009
Posts: 850
Likes: 0
Received 0 Likes
on
0 Posts
Year: 91 with lots of 01' parts
Model: Cherokee
Engine: 01' 4.0L
Thread
Thread Starter
Forum
Replies
Last Post
Wybuck
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
17
01-30-2024 08:59 AM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)